Advantage Page for:

• Product Manuals
• Product Drawings
• Configurators
• Software
• and much more!

What is Signature Calibration?

Signature Calibration saves you up to 90% of your sensor's set-up and reading time. The Signature Calibration equipped transducer will save you the time consuming (and frustrating!) task of setting up and calibrating a transducer with an instrument prior to each use. A small memory is installed in the sensor which contains all of the necessary set-up and calibration information for that transducer. After simply connecting the sensor to the instrument and turning on the power, all of these stored characteristics are used to completely set up and calibrate the system within seconds. This approach also eliminates all of the potential human error that may occur with manual set-ups, assuring accurate measurements and a good overall statistical data base.

Signature Calibration is available on most sensors as an on-board (internal) option, when the size of the sensor allows it. For smaller sensors, older Honeywell Sensotec sensors or another manufacturer's sensor, the in-line Signature Calibration module will provide the same benefits.

On-Board Module Option 53e*
Model	Model
41/43	RI
42/44	RF
45 * *	RM
73/75	STJE
415	TJE (All Models)
A-5 (All Models)	TG
A-10	UG
HL-A-5	V
HL-Z	WDTJE
HP	WDZ
LL-F	WG
LL-V	Z (All Models)
MIL	Z-2

On-Board Module Option 53e*
Model	Model
Accelerometers	GR-1
(All Models)	GR-3
11	H
13	K
31	L
34	LFH-71
47	LFH-81
53	LJS
81	LM
82	LV
440	MBH
811	MBL
911	P-30-P
A-105	QFFH-9
A-205	QSFK-9
D	QWFK-8M
F	QWLC-8M
G	S
	TH